Lamp States; Turning The Projector Off - Christie Boxer 30 Installation And Setup Manual

Lamp states

Learn the LED states of the lamp.
LED

Turning the projector off

When powering off in preparation for inspection or maintenance, always disconnect from AC.
1. To turn the lamps off, press and hold the Power button until you hear a beep.
When powering off the projector, allow the projector to complete its cool down cycle. Do not
immediately unplug the projector if this can be avoided.
2. To turn off power to the projector, disconnect from AC power.
Boxer 30 Installation and Setup Manual
020-102017-01 Rev. 1 (11-2015)
State
Off
On
Warming up
Cooling down
Hours exceed user limit
Failed to strike
Lamp off - Unknown
Lamp off - Interlock
Missing
Installation and setup
Description
Lamp is off.
Lamp is on.
Lamp is warming up.
Lamp is cooling down.
Displayed if the user set a warning
level and the hours exceed it.
Lamp failed to strike.
Lamp is off but the state is unknown
because the lamp driver could not
be communicated with.
Lamp is off due to an interlock being
triggered.
Lamp is not installed.
22