Table of Contents
Advertisement
Chapter 4
System Startup
Do not power on the instrument before completing the
preparation of reagents, water samples, standard
solutions, validation solution, and cleaning solution.
Reagents Preparation
Warning!
Exposure to and inhalation of chemicals
could be hazardous. Only trained and
qualified personnel can perform the work
described in this section of the Instruction
Manual.
Warning！
Since some of the reagents are corrosive,
it is recommended to order Thermo Fisher
approved reagents, which can not only
avoid personal injury and environmental
pollution,
measurement and good calibration results.
For the sake of safety, please observe the following rules:
•
Please wear personal protective equipment (PPE)
provided together with the instrument.
•
Ensure that all bottles are ventilated after
installation.
20 | Chapter 4
System Startup
but
also
ensure
accurate
•
Ensure compliance with applicable local accident
prevention laws and regulations.
•
Properly dispose of all chemicals and obey
applicable local laws and regulations.
Tubing Connection
Installation of Reagent Bottles and Tubing
Connection
This instrument is equipped with a total of 3 reagents
(Reagent 1, Reagent 2 and Reagent 3), a maximum of 2
standard solutions, one validation solution and one
cleaning solution. It is recommended to purchase them
directly from Thermo Fisher (www.thermofisher.com).
Please refer to Figure 4.1 for the installation of reagents,
standard solutions, validation solution, and cleaning
solution.
Refer to Table 4.1 for the port position of electronic rotary
valve (ERV) inside the instrument and its tubing
connection information.
8030cX Silica Analyzer
Advertisement
Table of Contents
