Table of Contents
Advertisement
•
Note: During installation, especially
installing external cables, do not discard the
rubber seal covers on the side of the instrument.
External cables need to pass through these
rubber seal covers to enable the IP65 protection.
Otherwise, IP65 protection will be compromised.
On-site instrument installation
1
Sequencer
(optional)
2
Regulation Valves
3
Flow cell
4
Sampling tube
8030cX Silica
5
Analyzer
Figure 3.1: On-site Installation of Silica Analyzer
Note:
If you need to separate chemical waste from clean rinse
wastewater, this analyzer needs to be equipped with two
liquid waste tanks, one for chemical waste and the other
for harmless cleaning waste. Be sure to properly label the
corresponding tubing and tank.
Liquid chemical wastes should be properly disposed
according to relevant waste handling requirement.
Due to the very limited quantity of chemical waste, it is
possible that it is okay to discharge the chemical waste
to drain. Please check to ensure the limited waste is okay
10
| Chapter 3 Installation
when
6
Power supply socket
7
Liquid clean waste
tubing
8
Liquid chemical waste
tubing
9
Liquid clean waste tank
Liquid chemical waste
10
tank
for your wastewater facility to handle or meet your
discharge regulation.
8030cX Silica Analyzer
Advertisement
Table of Contents
