Table of Contents
Advertisement
Intel® Server System M50FCP1UR System Integration and Service Guide
6.9
Ethernet Network Adapter for OCP* Replacement
This section provides instructions for replacement of an OCP* add-in card. OCP add-in cards will have one of
two possible methods to secure the card within the OCP bay. Refer to the section that supports the card type
to be replaced.
Pull-Tab and Thumb Screw – Section 6.9.1
•
Internal Lock – Section 6.9.2
•
Required Tools and Supplies
•
OCP Ethernet Network Adapter
Anti-static wrist strap and conductive workbench pad (recommended)
•
Phillips* head screwdriver #1
•
6.9.1
OCP* Adapter with Pull Tab Replacement
1. Loosen the thumb screw on the right side of the OCP adapter (see Letter A).
2. Pull the OCP adapter out of the bay using the tab on the left side of the OCP adapter (see Letter B).
3. Locate and carefully unpack the replacement card.
4. Align the OCP adapter with the open OCP bay slot and slide forward until the connectors make
secure contact (see Letter A).
5. Tighten the thumb screw on the right side of the OCP adapter (see Letter B).
80
Figure 108. OCP* Adapter with Pull Tab Removal
Figure 109. OCP* Adapter with Pull Tab Installation
Advertisement
Table of Contents
