Table of Contents
Advertisement
Intel® Server System M50FCP1UR System Integration and Service Guide
6.6
Riser Card Replacement
This section provides instructions for the replacement of a riser card.
Required Tools and Supplies
•
Replacement riser card accessory kit
Anti-static wrist strap and conductive workbench pad (recommended)
•
Phillips* head screwdriver #1
•
The system includes three different riser card brackets. The replacement instructions are the same for each.
1. Power off the system and disconnect the system power cords.
2. Remove the system top cover (see
3. (If present) Unscrew the four fastener screws on the chassis back panel. See
4. (If present) Disconnect all cables (internal and external) that may be attached to the riser assembly.
5. On the front and back of the riser card bracket, loosen the two screw heads securing the bracket to
the server board. See Letter A.
6. Grasp the riser card bracket with both hands and carefully pull it up and away from the chassis.
See Letter B
7. If an add-in card is present, remove it from the riser bracket assembly.
Figure 90. Chassis Riser Card Bracket Screws
Section
6.1.1).
Figure 91. Riser Card Bracket Removal
Figure
90)
71
Advertisement
Table of Contents
