Table of Contents
Advertisement
Natural gas
In this case the gas pressure
upstream of the nozzle has to
be adjusted; proceed as fol-
lows.
1 - Fill the well with 10 litres of
water.
2 - Turn off the gas supply
tap.
3 - Pull off knob (A) and dis-
assemble handle (B).
4 - Undo the screws (C) and
remove panel (D).
5 - Unscrew the screw (E).
6 - Connect the pressure gauge (F) to the pressure
test point .
7 - Turn the gas supply tap back on.
8 - Light the burner and turn the knob to the full flame
setting.
9 - Set the pressure to 0.80 kPa with screw (G).
10 - Allow the appliance to operate for 15 minutes,
then turn the knob to the low flame setting.
Note: if the flame goes out, light it with the knob.
11 - Set the pressure to 0.30 kPa with screw (H).
12 - Switch the appliance on and off repeatedly and
check that the pressure gauge readings remain
stable for 30 seconds.
Note: after making the setting, seal the screws (G) e (H)
with paint.
13 - Turn off the burner, disconnect the pressure
gauge and restore the initial conditions after com-
pleting the operation.
ADJUSTING THE LID COUNTER-BALANCING
To carry out this operation, proceed as follows.
1 - Fit the spanner (A) onto the hexagon (B).
2 - Keep a firm grip on the spanner (A) and undo the
locking screws (C).
3 - Turn the spanner (A) clockwise to load the spring
or anti-clockwise to release it.
4 - Once the correct balance is obtained, screw in the
screws (C) without tightening them fully.
5 - Use the spanner (A) to turn the shaft until it is lo-
cated in one of the seats provided.
6 - Fully tighten the screws (C).
A
B
C D C
Liquid gas
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off knob (A) and disassemble handle (B).
3 - Undo the screws (C) and remove panel (D).
4 - Fully tighten down screws (G) and (H).
5 - Restore the initial conditions after complet-
- 15 -
Note: after making the setting, seal the screws (G) e
(H) with paint.
ing the operation.
C
A
B
H
G
F
E
IDM-39604007600.tif
IDM-39603304700.tif
IT
AUS
DE
FR
ES
Advertisement
Table of Contents
