Table of Contents
Advertisement
Hardware options installation
Introduction
Install any hardware options before initializing the server. If multiple options are being installed, read the
installation instructions for all the hardware options to identify similar steps and streamline the installation process.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause electrostatic discharge.
Installing a redundant hot-plug power supply
Prerequisites
Before installing this option, be sure you have the following:
The components included with the hardware option kit
Procedure
1. Observe the following alerts:
CAUTION: All power supplies installed in the server must have the same output power capacity. Verify
that all power supplies have the same part number and label color. The system becomes unstable and
may shut down when it detects mismatched power supplies.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
2. Access the product rear panel.
3. Remove the blank.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or power
supply blank to cool before touching it.
4. Insert the power supply into the power supply bay until it clicks into place.
5. Connect the power cord to the power supply.
Hitachi Advanced Server HA810 G2 User Guide
47
Advertisement
Table of Contents
