Bunn Fast Cup Series Service & Repair Manual page 42

LOWER FRONT PANEL
Step 5: Align studs on top of Brew Module with
holes in top of machine interior.
Step 6: Swing bottom of Brew Module to align
metal plate with thumb screw holes.
Step 7: Replace Qty-2 thumb screws.
Step 8: Connect the wiring harness at the
12 pin connector junction located on
the right inner wall (located by upper
door hinge).
Step 9: Connect upper and lower brew tubes
going to the push-in fittings.
SERVICE
9
Brew
Module
42
5
6
8
7
Continued >