Bunn Fast Cup Series Service & Repair Manual page 126

Tank Module
- Removal Instructions
1
Turn off main water supply and disconnect power and
water going to the brewer.
2
Remove left & right side panel to access electrical and
plumbing connections.
Remove rear panel to access tank module.
4
Disconnect J13-16 pin connector from the
Input/Output Board.
3
J20-4 Pin
Disconnect the following pin connectors from the High
Voltage Board. J20-4, J16-3 and J8-5.
5
J13-16 Pin
a. Disconnect red jumper wire (a) at the limit thermostat
on the "Inlet Tank".
b. Disconnect the main red (L2) wire with the extra male
spade terminal (b) from the limit thermostat on the
"Inlet Tank".
126
J16-3 Pin
a
J8-5 Pin
b
Continued >