Bunn Fast Cup Series Service & Repair Manual page 41

LOWER FRONT PANEL
Brew Module Re-Installation
Hint: Easier to install module back into the
brewer frame when the brew module latch system
is engaged.
Step 1: Position Brew Module upright with flat
bottom on edge of table and module
mounting bracket away from table.
Step 2: Place hand on top of brew module.
Step 3: Push downward to compress the lower
piston with brew screen further into the
brew chamber.
Step 4: Compress until the upper latch system
fully engages in the slots (locked position).
SERVICE
Latch
1
4
41
3
2
Latch
Engaged
Continued >