Drip Tray - Bunn Fast Cup Series Service & Repair Manual

EXTERIOR
DRIP TRAY ASSEMBLY
Purpose: The drip tray is the collection area for
sanitize, rinse and expansion water. The water is
directed out a drain fitting, through a drain tube and
exits into the site drain. A drip tray detection circuit
is incorporated within the brewer to ensure drip tray
is in position for brewer operation. If the drip tray is
not present, brewer will not heat and user will not be
able to operate the brewer.
TEST INSTRUCTION
Enter Service Technician Mode and Select
Service icon
Step 1: Select and enter the Sensors tab.
Step 2: Located left side, The Drip Tray can be
tested for Installed and Removed position.
Step 3: If the brewer does not see the drip tray
in position, look for the magnet on the end
of the drip tray, must be present and be
clean for the magnetism to operate a switch
that is mounted in the brewer base.
Step 4: Magnet present and clean - Go to Rear
Panel section, perform Drip Tray Switch
testing procedure.
PART RELATES TO THE FOLLOWING SYMPTOM
• Message - Drip Tray Removed - Please Replace
the Drip tray
• Message - Finish Tank, Pre-Heat Tank, Inlet Tank
Heater Control OFF
SERVICE
1
22
3
2