Bunn Fast Cup Series Service & Repair Manual page 118

6
Locate the lower inlet tube going to the bottom of the brew
chamber. Disconnect tube at the fitting coming through
the side wall.
8
Remove 2 thumb screws at the bottom of the
Brew Module.
7
Disconnect the wiring harness at the 12 pin connector
junction located on the right inner wall (located by upper
door hinge).
9
The Brew Module is ready to be removed.
a. Grab the bottom of the Brew Module.
b. Gently pull outward to remove module
from brewer.
118
b
a