Bunn Fast Cup Series Service & Repair Manual page 124

6
STEP 6
Unscrew the 3/8" female flare from the main
bulkhead fitting.
NOTE: Retain flare gasket/seal.
8
Locate the lower inlet tube going to the bottom of the
brew chamber. Disconnect tube at the fitting coming
through the side wall.
10
Disconnect 2 pressure transducers from the wiring harness.
NOTE: Document harness color to each pressure
transducer.
7
Open lower and upper brewer doors. Locate the upper
piston outlet tubes. Disconnect each tube at the elbow
fittings coming through the side wall.
9
Disconnect all wires from quantity 9 solenoid valves.
NOTE: Document wiring harness color to each
solenoid valve.
11
Remove 2 slotted screws above the solenoid valves
securing the solenoid valve panel to the brewer frame.
124
STEP 7
Continued >