Bunn Fast Cup Series Service & Repair Manual page 122

a
6
b
c
Disconnect green wire (a) and (b) attached to brewer chassis.
Remove protective harness bushing (c) from housing.
Remove wiring harness with connectors through hole that
was previously disconnected in Step 4 and 5.
8
Disconnect quantity two red wires with 1/4 spade
terminals from the 3 amp grinder circuit breaker.
10
Use 7/16 deep well socket or extension to remove 2 hex
nuts on each end securing grinder module bracket to the
brewer frame.
7
Disconnect 3 grind motor 4 pin connectors.
NOTE: Document wiring harness color to each
grinder motor.
9
Remove 4 screws securing top cover. Remove cover with
attached harness and green ground wires.
11
Grab grinder module and lift upwards to clear mounting
studs and pull toward yourself. Set grinder module aside.
122