Lower Front Panel; Brew Module - Bunn Fast Cup Series Service & Repair Manual

LOWER FRONT PANEL

Brew Module Removal Instruction
Step 1: Open upper front door.
Step 2: Open lower front door.
Step 3: Remove Waste Bin.
Step 4: Remove drip tray.
Step 5: Remove Qty-4, thumb screws securing
the inner panel. Remove panel.
Step 6: Disconnect upper and lower brew tubes
going to the push-in fittings.
Step 7: Disconnect the wiring harness at the
12 pin connector junction located on
the right inner wall (located by upper
door hinge).
Step 8: Remove Qty-2, thumb screws at the
bottom of the Brew Module.
Step 9: Remove Brew Module
a) Grab the bottom of the brew module.
b) Gently pull outward to remove brew
module from the brewer.
SERVICE
3
4
6
Brew
Module
40
2
7
9b
9a
1
5
8