Table of Contents
Advertisement
XK10 Hardware
XK10 Software
Flatness
Level
Level
Calibrating
1
the spirit
levels
When levelling a
point of interest
to gravity, it is
recommended
to follow the
process of
calibrating the
levels before
Place launch on a stable,
measuring.
flat surface.
If not levelling
to gravity,
calibrating the
5
spirit levels is
not necessary
(refer to
'levelling',
details on
page 91).
Adjust the height of the
M unit on the pillars so
that the beam aligns
with the centre of the PSD.
88
XK10 alignment laser system
XK10 Applications
XK10 Applications
Straightness
Parallelism
Coaxiality
2
|| = 0.02 mm/m (mils/inch)
Using the adjuster screws
(orange), level the launch unit
according to the large spirit
levels (green).
6
AVOID EXPOSURE
Laser light is
emitted from
this aperture
AVOID EXPOSURE
Laser light is
emitted from
this aperture
Select '0' to zero the
laser reading.
Squareness
Spindle direction
3
Place the M unit 5 m to 10 m
away from the launch unit.
7
B
B
180º
A
A
Rotate the launch unit
180 degrees and turn the
sweeping beam towards the
centre of the M unit.
4
Open 'Values'.
8
|| = 0.02 mm/m (mils/inch)
Using the adjuster screws
(orange), level the launch unit
according to the large spirit
levels (green).
www.renishaw.com/xk10
Advertisement
Table of Contents
