Table of Contents
Advertisement
Battery safety
The XK10 system is supplied with a single LR14 (C)
primary alkaline battery for the launch unit. Once depleted,
dispose of the battery according to manufacturer's disposal
procedures: do not attempt to charge the battery. The other
system components contain built-in rechargeable batteries.
For information on charging procedures, see the relevant section of this
manual. For specific battery operating, safety and disposal guidelines,
refer to the battery manufacturers' literature (see details on next page).
•
The XK10 may be supplied or used with non-rechargeable alkaline
or lithium-thionyl chloride batteries.
•
Do not attempt to recharge the batteries.
•
Dispose of waste batteries in accordance with your local environmental
and safety laws.
•
Replace the batteries only with the specified type.
•
Ensure that all batteries are inserted with the correct polarity, in
accordance with the instructions in this manual and indicated on the
product.
•
Do not store batteries in direct sunlight.
•
Do not expose the batteries to heat or dispose of batteries in a fire.
•
Avoid forced discharge of the batteries.
•
Do not short circuit the batteries.
•
Do not disassemble, apply excessive pressure, pierce, deform or subject
the batteries to impact.
•
Do not swallow the batteries.
XK10 alignment laser system
LR14 (C)
battery location
•
Keep the batteries out of the reach of children.
•
Do not expose the batteries to water.
•
If the batteries are swollen or damaged do not use them in the product
and exercise caution when handling them.
On/off switches
www.renishaw.com/xk10
11
Advertisement
Table of Contents
