Renishaw XK10 Manual page 4

Legal information
International regulations and conformance
EC and UKCA compliance
Renishaw plc declares that the XM system complies with the
applicable directives, standard and regulations. A copy of the
full EC Declaration of Conformity is available upon request.
In compliance with BS EN 61010-1:2010 the product is safe to
use in the following minimum environmental conditions:
• Indoor use only
• Altitude up to 2000 m
• Maximum relative humidity (non-condensing) of 80% for temperatures
up to 31 °C decreasing linearly to 50% relative humidity at 40 °C
• Pollution Degree 2
USA and Canadian regulations
FCC notice
47CFR:2001 part 15.19
This device complies with Part 15 of the FCC rules. Operation is subject to
the following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
4 XK10 alignment laser system
47CFR:2001 part 15.105
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if not used in
accordance with this user guide, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference, in which case you will be required to correct the
interference at your own expense.
47CFR:2001 part 15.21
The user is cautioned that any changes or modifications, not expressly
approved by Renishaw plc or authorised representative, could void the user's
authority to operate the equipment.
47CFR:2001 part 15.27
This unit was tested with shielded cables on the peripheral devices. Shielded
cables must be used with the unit to ensure compliance.
www.renishaw.com/xk10