Electrical and power safety
•
The display unit power supply and device charging
cables must not come into contact with fluids, for
example, coolant on the floor.
•
The power supply unit must not be positioned
inside the machine volume.
•
The display unit has been qualified for use with the power supply
supplied with the system. A specification for this power supply unit can be
found on page 28.
•
In the event of damage to the single phase mains cabling section of
the power supply (power lead), all power must be isolated from the
equipment before any other action is taken.
•
Never connect the system to devices not intended to be used with the
XK10 system.
10
XK10 alignment laser system
Power connector
On/off switch
www.renishaw.com/xk10