Multiple Symbols - Honeywell 5010 User Manual

When the output sequence is Off , the bar code data is output to the host as the
imager decodes it.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Required
On/Not Required
*Off

Multiple Symbols

Note: This feature does not work when the Imager is in Low Power mode.
When this programming selection is turned On , it allows you to read multiple
symbols when the trigger is activated. If you press and hold the trigger, aiming
the Imager at a series of symbols, it reads unique symbols once, beeping (if
turned on) for each read. The imager attempts to find and decode new symbols
as long as the trigger is activated. When this programming selection is turned
Off , the Imager will only read the symbol closest to the aiming beam.
On
* Off
4 - 22