Legal Information - Deif GPC 300 Operator's Manual

Latched Over-current alarm example
The controller trips a breaker because of over-current. The operator then manually (that is, not using the controller) closes
the breaker while the Over-current alarm is still latched.
If another over-current situation arises, the controller does not trip the breaker again. The controller regards the original
Over-current latched alarm as still active, and it does not provide protection.
1.8

Legal information

Disclaimer
DEIF A/S reserves the right to change any of the contents of this document without prior notice.
The English version of this document always contains the most recent and up-to-date information about the product. DEIF does not
take responsibility for the accuracy of translations, and translations might not be updated at the same time as the English document.
If there is a discrepancy, the English version prevails.
Warranty
The rack may only be opened to remove, replace, and/or add a hardware module or the internal battery on PCM3.1. The procedure
in the Installation instructions must be followed. If the rack is opened for any other reason, and/or the procedure is not followed,
then the warranty is void.
If the display unit is opened, then the warranty is void.
Open source software
This product contains open source software licensed under, for example, the GNU General Public License (GNU GPL) and GNU
Lesser General Public License (GNU LGPL). The source code for this software can be obtained by contacting DEIF at
support@deif.com. DEIF reserves the right to charge for the cost of the service.
Trademarks
DEIF, power in control and the DEIF logo are trademarks of DEIF A/S.
®
Bonjour is a registered trademark of Apple Inc. in the United States and other countries.
® ®
Adobe , Acrobat , and Reader
States and/or other countries.
®
CANopen is a registered community trademark of CAN in Automation e.V. (CiA).
®
SAE J1939 is a registered trademark of SAE International
®
CODESYS is a trademark of CODESYS GmbH.
® ®
EtherCAT , EtherCAT P
GmbH, Germany.
®
Modbus is a registered trademark of Schneider Automation Inc.
®
Windows is a registered trademark of Microsoft Corporation in the United States and other countries.
All trademarks are the properties of their respective owners.
Copyright
©
Copyright DEIF A/S. All rights reserved.
OPERATOR'S MANUAL 4189341171C UK
®
are either registered trademarks or trademarks of Adobe Systems Incorporated in the United
®
, Safety over EtherCAT , are trademarks or registered trademarks, licensed by Beckhoff Automation
®
.
Page 8 of 91