Restore; Restore Restrictions - Deif GPC 300 Operator's Manual

8.4

Restore

8.4.1

Restore restrictions

Controller prerequisites
Before you restore a backup to a controller, the controller must meet these prerequisites:
Controller type
SINGLE genset controller
without mains breaker
SINGLE genset controller
with mains breaker
GENSET controller
MAINS controller
BUS TIE breaker controller
Not compatible backup files
Backup files or folders are not compatible with the current controller configuration if:
• The backup is from a different product type.
• The backup is from a different controller type.
• The backup is from a different controller configuration.
• The backup is from a controller with a different hardware configuration.
• The backup is not supported by the current controller software.
Restore network settings
If you use Restore IP address (IPv4) and controller ID, the controller must be powered off and powered on before the network
settings are restored.
Controller part of system
If the controller is part of the network communication between units, the processor and communication module is also
powered off. Make sure this does not affect your system before you power the controller off.
Data not restored
When you restore a backup file or folder to a controller, the event log and alarms are not restored.
OPERATOR'S MANUAL 4189341171C UK
Prerequisites
1. The generator breaker must be opened.
2. The engine must be stopped.
3. The controller must be in Switchboard control.
1. The generator breaker must be opened.
2. The mains breaker must be opened
3. The engine must be stopped.
4. The controller must be in Switchboard control.
1. The breaker must be opened.
2. The engine must be stopped.
3. The controller must be in Switchboard control.
1. The breaker must be opened.
2. The controller must be in Switchboard control.
CAUTION
Page 65 of 91