Table of Contents
Advertisement
6.3.1
Add or configure a view
Add a view
1. Select Add.
2. Select the template:
•
Summary information is shown under the preview:
•
3. Select
OK to display the measurements:
•
4. Select a measurement to configure.
Ready for operation
Home / Configure / View design
Select measurement
Engine
Generator
Busbar
Regulators
Local
Hardware
•
•
Select Clear to remove the selected measurement.
•
Select Done to confirm the measurement selected.
5. Add further measurements as needed.
6. Select Scale to configure the displayed range if needed.
OPERATOR'S MANUAL 4189341171C UK
12:00
Clear
Done
Page 41 of 91
Advertisement
Table of Contents
Troubleshooting
