Deif GPC 300 Operator's Manual page 35

Operator info
GB open cancelled
GB open not possible in SWBD
Not under LOCAL control
You can remove latches
MB close blocked *
MB close cancelled *
MB close unblocked *
MB open cancelled *
Start enable not activated
Static synchronisation activated
Static synchronisation deactivated
Synchronisation cancelled
NOTE * Applicable to SINGLE genset controller with mains breaker (MB).
OPERATOR'S MANUAL 4189341171C UK
Additional information
The GB open was cancelled by a GB close command.
In switchboard control, operator actions cannot be performed from the controller
interfaces.
The action cannot be performed unless the controller is in LOCAL mode.
There are acknowledged latched alarms in the alarm list that can be reset.
The Block MB close function is active. An open breaker cannot be closed.
The MB close was cancelled by a MB open command.
The Block MB close function is not active.
The MB open was cancelled by a MB close command.
The genset cannot start, because Start enable is not activated.
The digital input is activated. The controller will use static synchronisation.
The digital input is deactivated. The controller will use the synchronisation type
configured in the parameter.
The controller has cancelled the synchronisation (for example, if there is a blackout
during synchronisation).
Page 35 of 91