Table of Contents
Advertisement
Planning
• A non-combustible hearth is not necessary in front of
this appliance.
• Note that the appliance is installed at the framing
stage and secured to framing using support angles.
See page 24, 26. Wall fi nish is then installed
afterwards over the support angles up to the front
frame on the appliance, on the sides and up to the
stand-off s on the top.
30-3/4" (768 mm)
Combustible framing
allowed beneath fireplace.
When the appliance is
installed directly on
carpeting, tile or other
combustible material
other than wood
flooring, the appliance
shall be installed on a
metal or wood panel
extending the
full width and recessed
depth of the appliance
FRAMING DIMENSIONS
12
Wall Finish
to wall finish
16" (406 mm) min. straight out
or off the top venting.
Allow for elbow if rear vent with rise.
NOTE
When the appliance is installed directly on
carpeting, tile or other combustible material
other than wood flooring, the appliance shall be
installed on a metal or wood panel extending the
full width and depth of the appliance.
38-3/4" (984 mm) to underside of
header and cavity height
Framing
MINIMUM 1/2" (13 mm) space
between bottom of backing
plate and surface of hearth or
floor finish in front for air flow
Advertisement
Table of Contents
