Overview Of The Route Planning Function - JRC JMR-7230-S Instruction Manual

9.1 Overview of the Route Planning
Function
Table editing function
This function enables creation of a route in table format by using the [Route Planning] dialog box.
A route is created by entering each WPT into the WPT list.
For the details of route planning with table editing, refer to "9.6 Planning a Route by Using Table
Editing".
Graphic editing function
This function enables creating a route on a chart.
A route plan is created by adding a WPT on a chart.
For the details of route planning with graphic editing, refer to "9.7 Planning a New Route by Graphic
Editing".
Route planning safety checking function
This function checks the safety of the planned route.
For the details, refer to "9.9.1 Checking a route based on the safety standards".
Route planning limit checking function
This function checks whether the planned route does not violate the pre-defined limit.
For the details, refer to "9.9.2 Checking a route based on the limits".
Navigation calculating function
This function supports the calculation of distance and bearing that are required for navigation.
For the details, refer to "9.10 Navigation Calculation Function".
Import/Export function
This function imports/exports a route file.
For the details, refer to "9.11 Importing/Exporting a Route File".
Note
- When a route is created exceeding the limit value, an error message is displayed and Route
planning operation stops.
- If the distance between WPTs exceeds 150° in longitude, the route cannot be created.
Section 9 Route Planning 9-2