JRC JMR-7230-S Instruction Manual page 613

Setting Item
12 (12 to 16) NM Select a pulse width of 12 NM range.
Video Latitude Set up the radar image.
Video Noise Set up to remove noise and signals which
Rejection are considered to be clutters of radar
images.
Auto Dynamic Range When this is selected, the dynamic range
Control is automatically adjusted.
Process Switch Specify an area and set up a mode for
performing video processing on the inside
and outside of the area.
2nd Process Mode Set up a processing mode used in the
outside of the area. This is enabled when
other than [Off] is being selected in the
Process Switch combo box.
Process Switch Set up the boundary range of a particular
Range area.
Fast Target Detection When this item is enabled, high-speed
moving targets that are suppressed by the
scan correlation processing can be
displayed more easily.
This setting takes effect when the [2nd
Process Mode] is [PROC3 to 5].
Trails Mode Select a radar trail display mode.
Trails Ref Level Set up a video level required to draw radar
trails. The higher the level gets, the higher
the threshold value for drawing radar trails
becomes.
Description of Setting
18-11
Setting Value
<Radar Antenna 10kW>
SP1/MP1/MP2/LP1/LP2
<Radar Antenna 25kW>
SP1/MP1/MP2/MP3/LP1/LP2
<Radar Antenna 30KW>
MP1/MP2/MP3/LP1/LP2
<S-band solid state>
MP2/LP1/LP2
<X-band solid state>
SP1/MP1/MP2/LP1/LP2
Narrow
Normal
Wide
Super Wide
Off
Level1(Low)
Level2(High)
To enable: Select.
To disable: Clear.
Off
Range Fix
AUTO
PROC Off
3Scan CORREL
4Scan CORREL
5Scan CORREL
Remain
Peak Hold
0.1 to 25.5 NM
To enable: Select.
To disable: Clear.
True
Relative
Level1(Low)
Level2
Level3
Level4(High)
Section 18 Setting up the Operation Mode
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B