Checking Route Data; Checking A Route Based On The Safety Standards - JRC JMR-7230-S Instruction Manual

9.9 Checking Route Data

Route data is constantly checked based on the safety standards and limits.
These items are checked on the [Check Route] dialog box.
The [Check Route] dialog box appears by clicking on the [Show Route Check] button on the Route
Planning bar.
9.9.1 Checking a route based on the safety
standards
The result of safety check is displayed on the [Safety check] tab.
Count badge
Check box
[Jump] button
[Safety contour] box
When safety errors are detected, the number of errors is displayed on the count badge. When the error
count exceeds 999, "More" is displayed instead of the count.
The list of Cause and Result of the errors that were detected is displayed for each WPT prior to and
following the error occurrence point. The following causes are displayed.
Cause
SpeConAre(Traffic separation zone)
SpeConAre(Traffic crossing)
SpeConAre(Traffic roundabout)
SpeConAre(Traffic precautionary)
SpeConAre(Two way traffic)
SpeConAre(Deeper water route)
Section 9 Route Planning
WPT
Cause
Re-check button
Approval status (Result)
[Disregard] button
[Reset] button
9-64