Creating A Vertex By Entering The Position; Creating An Object With Ebl/Vrm Operation - JRC JMR-7230-S Instruction Manual

14.10.2.1 Creating a vertex by entering the position

1.
Click on the [Enter POSN] button on the drawing toolbar.
The [Enter Position] dialog box appears.
2.
Enter the latitude and longitude of the vertex of the object in the [Position] box and
click on the [Enter] button.
The position of the vertex of the object is determined.
The [Bearing] box and the [Distance] box are enabled.
3.
Enter the values of the latitude and the longitude of the next vertex in the [Position]
box. Alternatively, enter the bearing from the vertex that was determined immediately
previously in the [Bearing] box and the [Distance] input box.
4.
Click on the [Enter] button.
5.
Determine the positions of 3 or more vertices by repeating Steps 2 and 3.
6.
Adjust the parameters on the object property dialog box.
7.
To create an object in another position continuously, click on the [New] button of the
[Enter Position] dialog and repeat Steps from 2 to 6.

14.10.2.2 Creating an object with EBL/VRM operation

1.
Click on the [EBL/VRM] button on the drawing toolbar.
The cursor changes to the EBL/VRM reference point cursor. (Refer to "14.2.5 Creating an
object in the EBL/VRM mode ".)
2.
Click on the position of the reference point of the EBL/VRM marker.
The EBL/VRM marker is displayed.
3.
Place the EBL/VRM marker on the starting point and click the button.
A vertex is created on the position on which the button was clicked and the information is
reflected in the object property dialog box. (Refer to "14.2.8 Object property dialog box ".)
Starting point
4.
Click on the position of the reference point.
The EBL/VRM marker that determines the 2
Section 14 Creating a User Chart/ Updating a Chart Manually
nd
point is displayed.
14-94