JRC JMR-7230-S Instruction Manual page 600

17.8 Setting up Alert Processing
When [AMS] is selected in the classification pane, the [AMS] dialog is displayed on the edit pane.
In this dialog, the time to activate the action at the next stage when acknowledge is not performed for
an alert can be set up.
Enter the wait time until an alert at the next stage is generated in [Time Limit].
Reactivation of Silenced Alert:
Category A/B Time Limit: 30 seconds.
Category C Time Limit: Set, within the range from 0 to 300s, the time required to reactivate the alert
Transfer to BNWAS:
When a BNWAS (Bridge Navigational Watch Alarm System) is connected, specify the time to transfer
an unacknowledged alert to the BNWAS in a range between 0 and 30s.
Repetition of UNACK Warning:
Specify the time to regenerate an unacknowledged alert as an audible warning in a range between 16
and 300s. A warning will be generated repeatedly until it is acknowledged. The default value is 60 s.
Note
This is not applicable to the following warnings according to the Standard (operation that is defined
in the IEC62065 (TCS) or IEC61174 (ECDIS) Standard). Warning are escalated to alarm, if warning
was not acknowledged for the following times.
- Early Course Change Warning, Actual Course Change Warning, End Of Track Warning and
Track Control Stopped Warning: 30 seconds (fixed)
- Outside Anchor Watch Area Warning: 120 seconds. (fixed)
Section 17 Setting up Alerts
sound that was silenced temporarily.
17-16