Replacing A Tooth On A Backhoe Bucket - Case CX235C SR Operator's Manual

Replacing a tooth on a backhoe bucket

Removal
1. Place the bucket a few centimetres above the ground.
Stop the engine and remove the ignition key.
2. Turn the locking stud 90 ° in the clockwise direction
using a hexagonal wrench.
3. Remove the locking pin then remove the worn tooth
tip.
Installation
1. Clean the mating surface on the adaptor.
2. Engage a new tooth tip right up to the stop and hold it
in position.
3. Engage the locking pin until it is flush with the tooth tip.
4. Turn the locking stud 90 ° in the anti-clockwise direc-
tion using a hexagonal wrench.
NOTE: When replacing a tooth tip, it is advisable to re-
place the locking pin at the same time.
6 - MAINTENANCE
6-65
1
C319Z9-012
2
TX8XZ1-020
3
TX8XZ1-021