Table of Contents
Advertisement
2. Close the valve (1) on the fuel tank line and close the
valve (2) on the engine line.
3. Clean around the fuel filter body.
NOTICE: Never use the cleaner because that can
cause damage.
4. Loosen the drain plug (3) and the bleed screw (4).
5. Clean around the fuel filter body then remove it using
the wrench provided with the machine.
6. Install the new fuel filter element. Replace the fuel filter
body seal, then install the body, turning it until it is in
contact with the fuel filter head.
ATTENTION: Do not fill the filter body with fuel before
installing.
7. Tighten the body using the wrench, the tightening
torque must be from 28 - 32 N·m (20.7 - 23.6 lb ft).
NOTE: Bind tight within regulation torque.
8. Replace the drain plug (3) seal then install the drain
plug (3); the tightening torque must be between 8 - 12
N·m (5.9 - 8.9 lb ft)
ATTENTION: Overtightening can damage the seal.
ATTENTION: Never re-use the seal of the filter body
or the drain plug (3); they must always be replaced
with new seal.
NOTE: Bind tight within regulation torque.
6 - MAINTENANCE
6-30
8
BF67A47F
9
F3E62F90
10
QOIPZB-010
11
F3E62F90A
Advertisement
Table of Contents
