Case CX235C SR Operator's Manual page 268

3. Pull the clip outward, remove the bulb and install a bulb
of the same wattage ( 70 W).
ATTENTION: Never put your fingers on a tungsten iodide
bulb.
4. Install the clip and reconnect the plug.
5. Put the working light back into position and install the
mounting screws.
Upperstructure and cab headlight
1. Disconnect the plug.
2. Remove the four screws and tilt the headlight.
3. Pull the clip outward, remove the bulb and install a bulb
of the same wattage ( 70 W).
ATTENTION: Never put your fingers on a tungsten iodide
bulb.
4. Install the clip, put the headlamp back in position and
install the screws and the plug.
6 - MAINTENANCE
6-84
4
WNNEYW-003
5
PV5ETN-003
6
PV5ETN-004
7
PV5ETN-005