Stopping The Unit; Stopping The Engine - Case CX235C SR Operator's Manual

Crawler excavator
Table of Contents

Advertisement

STOPPING THE UNIT

Stopping the engine

1. Lower the attachment and the dozer blade (if
equipped) until it is resting on the ground.
2. Turn the engine throttle button (1) to low idle position
and let the engine run for 5 minutes or so.
NOTICE: In cold weather, let the engine run for about 10
minutes at idle speed.
NOTICE: Always let the engine run at idle before switch-
ing off completely, except in emergency situations.
3. Turn the ignition key (2) to the "Off" position.
NOTE: To activate the anti-theft protection when stopping
the engine, (refer to page 4-4).
NOTICE: If the engine is to be shut down for a consider-
able length of time, refer to page 4-44).
In the event of an emergency
In the event of an emergency or if it is not possible to stop
the engine using the ignition key, press the emergency
shut-down switch on the left-hand control arm.
ATTENTION: This switch should only be used in case of
an emergency. Do not use it on a day-to-day basis to stop
the engine.
4 - OPERATING INSTRUCTIONS
4-14
1
84BB2A7F
2
E6BCEC54

Advertisement

Table of Contents
loading

Table of Contents