Case CX235C SR Operator's Manual page 162

4. After switch (1) has been operated, the set flow willbe
displayed for a set amount of time.
NOTE: To prevent failure or damage to the tool, make
sure that you select the correct circuit configuration and
flow rate and pressure for the tool.
5. Unlock the pedal and engage the locking pin (1).
6. Use the control pedal to operate the hydraulic breaker.
ATTENTION: In Bucket mode, do not carry out operation
using auxiliary line. If you do that the warning message
"Auxiliary set-up required" will be displayed with buzzer
sound. Stop operation immediately and carry out auxiliary
set-up.
4 - OPERATING INSTRUCTIONS
4-34
4
208F89D4Z
5
DF9E19E2
6
SNKQ6K-002
7
VOHLGR-005