REMOVAL
1. Place the bucket flat on flat, horizontal ground.
Operate the attachment controls so that the
arm/bucket linkage pin is not gripped by the
weight of the arm.
2. Stop the engine and remove the starter switch
key.
3. Remove the snap rings and retaining pins then
remove the pins from the bucket.
4. Start the engine.
5. Disengage the attachment from the bucket and
save the linkage seals.
CT02E005
INSTALLATION
1. Install the linkage seals on the arm bushing
shoulders. Change them if necessary.
2. Start the engine. Extend the bucket cylinder rod
to bring it into its housing. Stop the engine and
remove the starter switch key.
3. Install the arm/bucket linkage pin, then the
retaining pins and the rings.
CT02E005A
4. Start the engine. Remove the bucket cylinder rod
to bring it in its housing, shut down the engine
and remove the starter switch key.
6-34551NA
CHAPTER 6 - MAINTENANCE AND ADJUSTMENTS
REPLACING A BUCKET - CX75SR, CX80
Figure 34
Figure 35
Issued 8-04 Bur
5. Install the connecting rod/bucket linkage pin then
the retaining pins and the snap rings.
6. Push the seals back into their housings.
7. Grease the linkage pins.
CT02E005B
Figure 36
6-13