Table of Contents
Advertisement
Level in the reservoir
1. Place the machine on flat, level ground and place the
attachment in the position shown. Raise the dozer
blade (if equipped). Stop the engine and remove the
ignition key.
2. The oil should be in the middle of the indicator. Add
more oil if necessary. See "Filling the reservoir".
Filling the reservoir
1. Release all pressure in the hydraulic reservoir. Refer
to page 6-34.
2. Clean the cover plate and the area around the plate.
Remove the cover plate and add hydraulic fluid to the
reservoir as required.
3. Replace the cover plate seal if required and install the
cover plate.
NOTICE: Make sure that no contaminant (water, sand
etc.) enters the reservoir during filling.
6 - MAINTENANCE
6-37
1
049A36F8
2
BE292EDD
3
05128FF9
Advertisement
Table of Contents
