Table of Contents
Advertisement
1.
Engine coolant temperature gauge
Displays the temperature of the engine coolant.
The lower zone indicates that the engine coolant tem-
perature is low.
When the temperature gauge display reaches the up-
per zone, an alarm sounds and "Over heat" is dis-
played (see "Message screens").
Lower the engine speed.
If the temperature does not go down, stop the engine,
remove the ignition key, and investigate the cause.
2.
Hydraulic oil temperature gauge
Displays the temperature of the hydraulic oil.
The lower zone indicates that the hydraulic oil tem-
perature is low.
When the temperature gauge display reaches the up-
per zone, an alarm sounds and "Over heat" is dis-
played (see "Message screens").
Lower the engine speed.
If the temperature does not go down, stop the engine,
remove the ignition key, and investigate the cause.
3.
Fuel gauge
Displays the remaining amount of fuel by the number
of lit segments.
When all are lit, it indicates that the fuel tank is full.
When only 1 is lit, an alarm sounds and "Low fuel" is
displayed (see "Message screens").
NOTE: It is not necessary to wait until the fuel tank
is empty before filling with fuel. If the tank becomes
empty, air bleeding of the fuel system is required.
4.
Work mode icon
These indicators display the initial work mode and
the engine speed that was selected with the engine
acceleration button and work mode selector. (Refer
to page 3-53).
5.
Travel mode icon
At low speed, is displayed.
At high speed, is displayed.
6.
Working light
Displayed when the light is on.
7.
Engine auto idling and stop selection display
Displayed when auto idling is selected.
"Auto n/min".
3 - CONTROLS/INSTRUMENTS
8.
Free swing, swing parking and anti-theft protection
9.
Displays the selected attachment
Hydraulic breaker
Crusher grapple
10. Clock display
(Refer to page 3-43).
11. Auxiliary setting display
When an option circuit is mounted, the selected flow
and pressure are displayed.
Icon display
The setting that the wiper, idling and glow switches
are switched to are displayed largely in the middle of
display.
• Wiper operation
3-19
Displayed when auto stop is selected.
"Auto idle stop".
Displayed when auto idling and
auto stop are selected.
n/min" and "Auto idle stop".
Displayed when swing parking is operat-
ing (for service use only).
Displayed when the anti-theft protection
function is operating.
Displayed when free swing is operating.
3
MUC8LU-043Z
"Auto
Advertisement
Table of Contents
