Table of Contents
Advertisement
Cleaning and replacement of the suction filter
1. Release all pressure in the hydraulic reservoir. Refer
to page 6-34.
2. Clean the top of the hydraulic reservoir and clean the
suction filter cover.
3. Remove the cover (1) and O-ring (2) on the top of the
suction filter rod assembly.
4. Remove the filter (3) and clean with solvent. Dry it
completely and check it for any damage. If there is
any damage on the surface, replace it with a new one.
5. Install a new O-ring (2), install the filter (3) and rod
assembly.
6. Install the cover (1).
7. Check the level of the hydraulic fluid and add more if
necessary. See "Filling the reservoir".
ATTENTION: Install a new inlet screen every 5000 hours
of operation or when the hydraulic fluid is changed.
6 - MAINTENANCE
6-39
6
05128FF9
7
C62B0F5A
Advertisement
Table of Contents
