R&S Power Viewer - R&S NRP P Series User Manual

®
R&S NRPxxP
nect the power sensor as described in
on page 12.
Connect the power sensor to the signal source.
2. Connect the power sensor to the computer as shown in
For a detailed description, refer to
on page 14.
Starting a measurement
For a detailed description of how to measure in this setup, refer to the operating man-
ual of the R&S NRPV.
1. Start the R&S NRPV.
2. Execute zeroing.
Note: Turn off all measurement signals before zeroing. An active measurement
signal during zeroing causes an error.
3. Switch on the test signal of the signal source.
4. Start a measurement.
5.4 R&S Power Viewer
The R&S Power Viewer is software that simplifies many measurement tasks. It is provi-
ded on your documentation CD-ROM and on the Rohde & Schwarz website as a sepa-
rate standalone installation package.
Required equipment
●
R&S NRPxxP power sensor
●
R&S NRP‑ZKU cable or an R&S NRP‑Z5 sensor hub and an R&S NRP‑ZK6 cable
to connect the power sensor to the computer
●
Computer with installed:
–
–
User Manual 1179.5760.02 ─ 02
R&S NRP Toolkit version 4.20 or higher
R&S Power Viewer version 9.2 or higher (refer to the operating manual of the
R&S Power Viewer for a description of the installation process)
Chapter 3.4, "Connecting to a
Figure
Chapter 3.7.1.1, "Simple USB
Operating concepts
R&S Power Viewer
DUT",
5-1.
connection",
24