R&S NRP P Series User Manual page 71

®
R&S NRPxxP
1.00
0.00
Figure 8-6: PDF measurement parameter
1 = Average power
2 = Peak power
For information on querying the measurement results, see
measurement
8.6.6.1 Configuring the analysis window
Set the number of analysis window repetitions using
AVERage:COUNt. For defining start, length and exclusion period, use the following
commands:
SENSe<Sensor>:STATistics[:EXCLude]:MID:OFFSet[:TIME]
SENSe<Sensor>:STATistics[:EXCLude]:MID:TIME
SENSe<Sensor>:STATistics:OFFSet:TIME
SENSe<Sensor>:STATistics:TIME
SENSe<Sensor>:STATistics[:EXCLude]:MID:OFFSet[:TIME] <time>
Sets the start of an exclusion interval in the analysis window, referenced to the start of
the analysis window.
All other settings are the same as for the timeslot mode, see
measurement",
Parameters:
<time>
SENSe<Sensor>:STATistics[:EXCLude]:MID:TIME <time>
Sets the length of an exclusion interval in the analysis window.
User Manual 1179.5760.02 ─ 02
-30.00
results", on page 106.
on page 59.
Range:
*RST:
Default unit: s
Configuring the measurement modes
2 1
0.00
..............................................................71
......................................................................... 72
..................................................................................... 72
0.0 to 0.3
0.0
Remote control commands
Chapter 8.9.6, "Statistics
SENSe<Sensor>:TRACe:
................................................71
Chapter 8.6.3, "Timeslot
dBm
71