Configuring The Measured Values - R&S NRP P Series User Manual

®
R&S NRPxxP

8.4.2 Configuring the measured values

Before starting a measurement, you can configure the measurand or enable the mea-
surement of additional-measured values.
CALCulate:FEED
SENSe<Sensor>:AUXiliary
CALCulate:FEED <mode>
If you query measurement data using
AVG]?, the power sensor returns data of the measurand that was configured before.
Generally, this measurand is the average power. However, the power sensor can also
output data of other measurands.
To configure which measurand the
command reads, use the CALCulate:FEED command before the measurement is ini-
tiated. Depending on the measurement mode, the following settings are possible:
SENS:FUNC
"POWer:AVG"
"POWer:BURSt:AVG"
"POWer:TSLot:AVG"
"XTIMe:POWer"
"XPOWer:CCDFunction"
"XPOWer:PDFunction"
Parameters:
<mode>
User Manual 1179.5760.02 ─ 02
............................................................................................................. 40
............................................................................................... 41
FETCh<Sensor>[:SCALar][:POWer][:
FETCh<Sensor>[:SCALar][:POWer][:AVG]?
Possible CALC:FEED
"POWer:AVERage"
"POWer:PEAK"
"POWer:RANDom"
"POWer:AVERage"
"POWer:PEAK"
"POWer:RANDom"
"POWer:AVERage"
"POWer:PEAK"
"POWer:RANDom"
"POWer:TRACe"
"POWer:PEAK:TRACe"
"POWer:RANDom:TRACe"
CCDF:TRACe
PDF:TRACe
*RST: "POWer:AVERage"
Remote control commands
Preparing for the measurement
Meaning
Average value
Peak value
Randomly selected value from the
measurement interval
Average value
Peak value
Randomly selected value from the
measurement interval
Average value
Peak value
Randomly selected value from the
measurement interval
Measurement sequence
Peak value of the samples per
trace point
Randomly selected value of the
samples per trace point
Complementary cumulative distri-
bution function
Probability density function
40