R&S NRP P Series User Manual page 16

®
R&S NRPxxP
Setup
1
Figure 3-2: Setup with an R&S NRP-Z5 sensor hub
1 = External power supply unit
2 = Connect to AC power supply.
3 = Connect to computer with USB host interface.
4 = Optional: Connect to trigger source.
5 = Optional: Connect to triggered device.
6 = R&S NRP‑Z5 sensor hub
7 = Signal source (DUT)
8 = R&S NRPxxP power sensor
9 = R&S NRP‑ZK6 cable
Set up as shown in
1. Connect the R&S NRP‑ZK6 cable to the power sensor. See
the host interface of the power sensor"
2. Connect the power sensors to the R&S NRP‑Z5 sensor hub. You can connect up to
four power sensors.
3. Connect the R&S NRP‑Z5 to the computer.
4. NOTICE! Incorrectly connecting or disconnecting the power sensor can damage
the power sensor or lead to erroneous results. Ensure that you connect or discon-
nect the power sensor as described in
on page 12.
Connect the power sensors to the signal sources.
User Manual 1179.5760.02 ─ 02
2
Figure 3-2.
Connecting to a controlling host
4 5
3
on page 13.
Chapter 3.4, "Connecting to a
Preparing for use
6
9
"To connect a cable to
DUT",
7
8
16