R&S Power Viewer - R&S NRP Series User Manual

®
R&S NRPxxA(N)
5.5 R&S Power Viewer
The R&S Power Viewer is software that simplifies many measurement tasks. It is provi-
ded on your documentation CD-ROM and on the Rohde & Schwarz website as a sepa-
rate standalone installation package.
Required equipment
●
R&S NRPxxA(N) power sensor
●
R&S NRP‑ZKU cable or an R&S NRP‑Z5 sensor hub and an R&S NRP‑ZK6 cable
to connect the sensor to the computer
●
Computer with installed:
–
–
If you want to use an android device like a tablet or a smartphone, use the R&S Power
Viewer Mobile. For details, see
Setup
1
Figure 5-3: Setup with the R&S Power Viewer
1 = Signal source
2 = R&S NRPxxA(N) power sensor
3 = Host interface connector
4 = R&S NRP‑ZKU cable
5 = USB connector
6 = Computer with installed R&S Power Viewer
1. NOTICE! Incorrectly connecting or disconnecting the power sensor can damage
the power sensor or lead to erroneous results. Ensure that you connect or discon-
nect the power sensor as described in
on page 14.
Connect the power sensor to the signal source.
2. Connect the cables as shown in
For a detailed description, refer to
on page 17.
User Manual 1177.6017.02 ─ 08
R&S NRP Toolkit V 4.20 or higher
R&S Power Viewer version 9.2 or higher (refer to the operating manual of the
R&S Power Viewer for a description of the installation process)
2
NRP
3-Path Diode Power Sensor
MHz to GHz, 100 pW to 200 mW (−70 dBm to +23 dBm)
SMART SENSOR TECHNOLOGY
Chapter 5.6, "R&S Power Viewer
3
4
Chapter 3.4, "Connecting to a
Figure 5-3.
Chapter 3.7.1.1, "Simple USB
Operating concepts
R&S Power Viewer
Mobile", on page 37.
6
5
DUT",
connection",
36