Common Commands - R&S NRP P Series User Manual

®
R&S NRPxxP
Example:
Definition: [SENSe<Sensor>:]AVERage:COUNt:AUTO:NSRatio <nsr>
Command: AVER:COUN:AUTO:NSR 0.01
Special characters | and { }
|
{ }

8.3 Common commands

The common commands are taken from the IEEE 488.2 (IEC 625-2) standard. The
headers of these commands consist of an asterisk * followed by three letters.
*CLS
*ESE
*ESR?
*IDN?
*IST?
*OPC
*OPT?
*PRE
*RCL
*RST
*SAV
*SRE
*STB?
*TRG
*TST?
*WAI
*CLS
Clear status
Resets the following:
●
Status byte (STB)
●
Standard event register (ESR)
●
EVENt part of the QUEStionable and the OPERation register
●
Error/event queue
User Manual 1179.5760.02 ─ 02
A vertical bar in parameter definitions indicates alternative possibilities in the sense of
"or". The effect of the command differs, depending on which parameter is used.
Example:
Definition: INITiate:CONTinuous ON | OFF
Command INITiate:CONTinuous ON starts the measurements
Command INITiate:CONTinuous OFF stops the measurements
Parameters in braces can be included in the command once, several times or not at all.
...............................................................................................................................35
...............................................................................................................................36
.............................................................................................................................36
..............................................................................................................................36
.............................................................................................................................. 36
.............................................................................................................................. 36
.............................................................................................................................37
.............................................................................................................................. 37
...............................................................................................................................37
...............................................................................................................................37
...............................................................................................................................37
.............................................................................................................................. 38
.............................................................................................................................38
.............................................................................................................................. 38
............................................................................................................................. 38
............................................................................................................................... 38
Remote control commands
Common commands
35