Selecting / Deleting A Job; Selecting A Job - Sokkia 30R Series Operator's Manual

21. SELECTING / DELETING A JOB

21.1

Selecting a JOB

Select the current JOB and Coordinate Search JOB.
• A total of 10 JOBs have been prepared, and JOB1 was selected when your SET
was shipped from the factory.
• The names of the JOBs have been preset as JOB1 to JOB10; you can change
them to any names you wish.
• Scale factor can be set for each JOB. Only scale factor of the current JOB can
be edited.
Current JOB
Measurement results, instrument station data, known points data, notes and
coordinate data are recorded in the current JOB.
Registering known point data: "22.1 Registering/Deleting Known Point
Data".
Coordinate Search JOB
The registered coordinate data in the JOB selected here can be read into
coordinate measurement, resection measurement, setting-out
measurement, etc.
Scale correction
SET calculates horizontal distance and coordinates of a point using
measured slope distance. If scale factor has been set, scale correction is
carried out during calculation.
Corrected horizontal distance (s) = Horizontal distance (S) ×
• When scale factor is set to "1.00000000", the horizontal distance is not
corrected.
PROCEDURE JOB selection and scale factor setting
1. Select "JOB" in Memory Mode.
100
Scale factor (S.F.)
Memory
JOB
Known data
Code