Allocating Key Functions - Sokkia 30R Series Operator's Manual

24. CHANGING THE SETTINGS
24.2

Allocating Key Functions

It is possible to allocate the softkeys in Meas mode to suit the measurement
conditions. It is possible to operate the SET efficiently because unique softkey
allocations can be preset to suit various applications and the ways that different
operators handle the instrument.
• The current softkey allocations are retained until they are revised again, even
when the power is cut off.
• It is possible to register two sets of key function allocations: user setting 1 and
user setting 2.
• It is possible to recall the softkey arrays registered for User 1 and User 2 as
necessary.
• When softkey allocations are recorded and registered, the previously recorded
key settings are cleared. When a softkey array is recalled, the key array is
changed to the key array that has been recalled, clearing the previous key
array. Be sure to remember this.
The following are the softkey allocations when the SET was
shipped.
Page 1 [DIST] [
Page 2 [MENU] [TILT] [H.ANG] [EDM]
Page 3 [MLM] [OFFSET] [REC] [S-O]
The following functions can be allocated to the softkeys.
[DIST] : Distance measurement
[ SHV] : Switch between angle display and distance display
[0SET] : Set horizontal angle to 0
[COORD] : Coordinates measurement
[REP] : Repetition measurement
[MLM] : Missing line measurement
[S-O] : Setting-out measurement
[OFFSET] : Offset measurement
[REC] : To Record menu
[EDM] : Setting EDM
[H.ANG] : Set required horizontal angle
[TILT] : Display tilt angle
120
SHV] [0SET] [COORD]