Selecting/Deleting A Job; Selecting A Job - Sokkia iM-50 Series Operator's Manual

29.SELECTING/DELETING A JOB

29.1 Selecting a JOB

Select the current JOB and Coordinate Search JOB.
• A total of 99 JOBs have been prepared, and JOB1 was selected when your iM was shipped from the factory.
• The names of the JOBs have been preset as JOB1 to JOB99; you can change them to any names you wish.
• Scale factor can be set for each JOB. Only scale factor of the current JOB can be edited.

Current JOB
Measurement results, instrument station data, known points data, notes and coordinate data are recorded
in the current JOB.
Registering known point data: "30.1 Registering/Deleting Known Point Data".

Coordinate Search JOB
The registered coordinate data in the JOB selected here can be read into coordinate measurement,
resection measurement, setting-out measurement, etc.

Scale correction
iM calculates horizontal distance and coordinates of a point using measured slope distance. If scale factor
has been set, scale correction is carried out during calculation.
Corrected horizontal distance (s) = Horizontal distance (S) × Scale factor (S.F.)
• When scale factor is set to "1.00000000", the horizontal distance is not corrected.
Horizontal distance: "33.1 Observation Conditions - Angle/Tilt" Observation Condition  Horizontal
distance (H Dist)
PROCEDURE JOB selection and scale factor setting
1. Select "JOB" in Data Mode.
2. Select "JOB selection".
<JOB selection> is displayed.
3. Press [LIST].
• JOB can also be selected by pressing {}/{}.
• The numbers to the right represent the number of data
items in each JOB.
• "*" means that the JOB has not been output to an external
device yet.
Data
JOB
Known data
Code
JOB
JOB selection
JOB details
JOB deletion
Comms output
Comms setup
J O B s e l e c t i o n
: J O B 1
C o o r d s e a r c h J O B
: J O B 1
L I S T
162