Recalling The Measured Data - Sokkia 30R Series Operator's Manual

11. DISTANCE MEASUREMENT
3. Press [STOP] to quit distance
measurement.
• Each time [
S (Slope distance), H (Horizontal
distance) and V (Height
difference) are displayed
alternately.
• If the single measurement mode is selected, measurement automatically stops
after a single measurement.
• During fine average measurement, the distance data is displayed as S-1, S-2,
... to S-9. When the designated number of measurements has been completed,
the average value of the distance is displayed in the [S-A] line.
• The distance and angle that are most recently measured remain stored in the
memory until the power is off and can be displayed at any time.

"11.3 Recalling the Measured Data"

11.3 Recalling the Measured Data
The distance and angle that are most recently measured remain stored in the
memory until the power is off and can be displayed at any time.
The distance measurement value, vertical angle, horizontal angle, and the
coordinates can be displayed. Distance measurement values converted into the
horizontal distance, elevation difference, and the slope distance can also be
displayed.
PROCEDURE
1. Allocate the [RCL] softkey to the
Meas mode screen.
"24.2 Allocating Key Functions"
40
SHV] is pressed,