3. Press [OK].
<Instrument Station Data Setting>
is restored.
• Press [EDIT] to edit the
coordinate data that was read in.
Editing does not affect the
original coordinate data. After
editing, the point number is no
longer displayed.
• The point number that was read in is displayed until the current JOB is changed.
• When [SRCH] is pressed, SET searches data in the current JOB first, then in
the Coordinate Search JOB.
• If more than two points with the same point name exist in the current JOB, SET
finds the newer data only.
12.2
Azimuth Angle Setting
Based on the instrument station coordinates and backsight station coordinates
which have already been set, the azimuth angle of the backsight station is
calculated.
PROCEDURE
1. Select "Stn.Orientation", then "Set
H angle" in <Coord.>.
12. COORDINATE MEASUREMENT
47